bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Thor Chateau Motorhome


  • Do I Have to Drill Holes in My 2018 Ford E-450 Frame to Install Roadmaster Rear Anti-Sway Bar
  • Thanks for reaching back out and pointing out the video you found that in! I checked out the video you referenced about the Roadmaster Rear Anti-Sway Bar # RM-1139-147 install on a 2019 Ford E-Series Cutaway (see linked) and while Ryan did ultimately install the links back to where the factory ones were located, he only did so because he was unable to properly drill and install the links into the vertical position like the instructions called for. The sway bar will still work like this...
    view full answer...

  • Travel Trailer Frame Assembly and Glass
  • If it isn't held in with screws there should be some type of adhesive on it; I wish there was an easy way for me to tell you exactly how but realistically there isn't going to be a way that is particularly easy for you to remove your assembly if it is stuck on with adhesive. The Lippert Components 12" x 21" Inner and Outer Entry Door Window Frame with Seal # LC363369 just snaps together so it is possible you may be able to unsnap your assembly as well.
    view full answer...

  • Does LED Trailer Tail Light DG52721PB Need Grommet For Installation
  • Nope, a grommet is not required in order for you to install LED Trailer Tail Light w/ Reflector - Weatherproof - 4 Function - 76 Diodes - Clear/Red Lens # DG52721PB. The # DG52721PB come in a mounting bracket already with holes for screws on the top, bottom, and sides.
    view full answer...

  • Can the Portable Power Watchdog Surge Protector with Bluetooth Be Reset
  • The Portable Power Watchdog Surge Protector with Bluetooth part # HU97FR can be reused after being tripped. That said, you will need to replace the surge module first (Replacement Surge Module for Power Watchdog Surge Protector part # HU48FR).
    view full answer...

  • Hopkins Electronic LED Smart Level Mounting Instructions For A Motorhome
  • The instructions for mounting the Hopkins Electronic LED Smart Level # HM08201 are the same for motorhomes and trailers. You can attach the level to your motorhome with the included bracket and adhesive backing. It also has three pre-drilled holes in it, as well as included hardware for a permanent mount installation.The leveler can be removed from the bracket if needed. If it were me I would place the Smart Level # HM08201 near stabilizer jack controls, if they are powered, or near...
    view full answer...

  • How To Replace Old RV Awning Fabric
  • I have great news! Replacing an awning fabric is fairly straightforward with the right tools and mechanical knowledge. Thankfully, we have all the resources you'll need to complete the task. I have attached for you below a help article that shows you how to replace your awning fabric with some videos as well. The Solera 10' Sand Fade RV Awning Roller and Fabric part # LCV000231508 will then be an excellent option for replacement. We have tons of other sizes and colors as well attached below.
    view full answer...

  • Wiring Installation on Command Electronics Triple LED Trailer Tail Light
  • The Command Electronics Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1 # CE44VR does not come with any instructions but the wiring diagram can be found on the rear of the lens housing if you pull back the foam pad. We've also covered this in detail in our review video, which I've attached to this answer and outlined below. Red- stop and turn White- Ground Black- Tail Lights Purple- Reverse/Backup
    view full answer...

  • Can the Monitor Light and CoachLink be Hooked to the Same Wire
  • For starters, a 2015 Jeep Grand Cherokee and 2015 Jeep Wrangler are very different vehicles in regards to flat-towing components so looking at installation videos on a Wrangler is just going to confuse you. The Grand Cherokee actually does not have an active stop light circuit so you will need to use the Roadmaster Stop Light Switch Kit part # RM-751449. The Jeep Wrangler does have an active stop light switch circuit which is why you need to use the Roadmaster Brake-Lite Relay Kit part...
    view full answer...